生态环境知识服务平台
}
首页>知识导航 > 大气环境 > 大气的热力作用 > 受热过程
发布时间 收起
强制性标准 收起
中标分类 收起
标准状态 展开
标准组织 展开
来源数据库 展开
相关度
订阅
至 收起
  • 服务由 WF 提供

    DIN EN 12877-4-2000 - 现行
    The document describes a method for determinating the colour stability of colouring materials under defined conditions in plastics by two-roll milling. The result of the determination is a relative value, not an absolute one. The method is mainly applicable for testing colouring materials in polyvinyl chloride.#,,#
    着色剂磨损老化试验染料温度热学聚氯乙烯热稳定性塑料耐力色牢度热阻颜色颜料试验
  • 服务由 WF 提供

    DIN EN 12877-1-2000 - 现行
    The document gives a general introduction to the most widely used methods for determination of colour stability during processing of colouring materials in plastics under the influence of heat. It also specifies those details which are common to the various test methods described in the subsequent parts. The choice of the test method depends on the plastics material to be coloured, the method of processing and the end-use requirements.#,,#
    试验颜料材料热性质颜色热阻热试验色牢度耐力塑料热稳定性热学温度染料着色剂
  • 服务由 WF 提供

    T/CSTM 00537-2021 - 2021年05月11日 - 现行
    本文件规定了光功率分析法测试薄膜材料相变温度的术语和定义、原理、仪器和试剂、样品处理、仪器校准、测试过程、数据处理、不确定度评定和测试报告等。本文件适用于厚度为5 nm~100 μm的薄膜材料相变温度的测试,薄膜材料应相变前后光反射率不同且在测试温区内受热不分解、不挥发。厚度大于100 μm的材料可参照执行。
  • 服务由 WF 提供

    DL/T 2794-2024 - 2024年09月24日 - 现行
    本文件规定了火力发电厂金属材料在高温烟气/煤灰条件下腐蚀试验的试验原理、试验装置及条件、试样、试验过程、结果分析和试验报告的基本要求。本文件适用于火力发电厂锅炉受热面金属材料在高温烟气/煤灰条件下的腐蚀试验,金属材料在其他高温气体、高温气体/固体环境中的腐蚀试验可参照执行。
回到顶部