-
ANSI/ASTM D5677-2005
- 2005年11月29日
- 现行
This specification covers a reinforced plastic pipe and fittings system made from epoxy resin and glass-fiber reinforcement, together with adhesive for joint assembly, intended for service up to 150F (65.6C) and 150-psig (1034-kPa) operating pressure and surges up to 275 psig (1896 kPa) in aviation jet turbine fuel lines installed below ground. The dimensionless designator NPS has been substituted in this specification for such traditional terms as nominal diameter, size, and nominal size. The values stated in inch-pound units are to be regarded as standard. The values in parentheses are for information only. The following safety hazards caveat pertains only to the test method portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1There is no similar or equivalent ISO standard.
胶粘连接飞行器部件航空燃料跌落试验环氧树脂灯丝配件燃料供应管道冲击抗冲击(强度)管塑料塑料管涡轮机
-
FZ/T 64034-2014
- 2014年12月24日
- 现行
本标准规定了纺粘/熔喷/纺粘(SMS)法(纺粘、熔喷可以是一层或多层)非织造布的技术要求、试验方法、检验规则、包装、标志、贮存和运输。本标准适用于以丙纶为主要原料,以热轧粘合方式加固的SMS产品。
-
FZ/T 64093-2022
- 2022年04月08日
- 现行
本文件规定了聚乳酸短纤维非织造布的产品分类、技术要求、试验方法、检验规则、包装、标志和贮运要求。本文件适用于以纯聚乳酸短纤维为原料,梳理成网后用热粘合方法加固生产的单位面积质量≤60g/m2的非织造布。
-
GB/T 17987-2000
- 2000年03月03日
- 现行
本标准规定了作为沥青防水卷材用基胎的聚酯非织造布(聚酯毡)的产品规格、代码、技术要求、试验方法、检验规则、包装和标志等。 本标准适用于以涤沦纤维为原料,经针刺或热粘合加固后,再经热或化学粘合工艺制成的非织造布产品。
布防水材料聚酯沥青非织造布
-
FZ/T 64005-2011
- 2011年05月18日
- 作废
本标准规定了卫生用薄型非织造布的产品分类、技术要求、试验方法、检验规则及包装和标志。 本标准适用于鉴定以符合卫生用要求的短纤维为原料,纤网经热熔粘合加固而制成的薄型非织造布的品质。 本标准适用于18 g/m2~30 g/m2一次性卫生用产品的面料和包覆材料。
卫生用薄型非织造布非织造布标准